Mechanical rangschikking for ordinary stacking using optional stacking plak.
Four x Spartan(TM)-6 XC6SLX150 FPGAs wired like Two sets of Icarus houtvezelplaat (to be confirmed by testing). Icarus bitstream compatible (to be confirmed by testing).
12A, 1.2V power supply for each array FPGA. Input is 12V nominal from jack, disk drive connector (Molex), PCIe graphics power connector (6 way) and Pheonix connector.
Manages array can shutdown power to each FPGA on individual fundament.
Controls clock generator and clocks to each FPGA.
Can read temperature sensors (affixed to and next to each array FPGA).
Can drive JTAG chain (needs development work).
Controller powers up on USB supply only for debug.
Can be used to pass gegevens inbetween FPGAs.
Supports up and down interfaces for gegevens flow within houtvezelplaat stacking.
FT4232 USB controller can be used ter numerous ways including Four COM ports. Can also support JTAG engine. Product is supplied with 1M USB cable.
For mode setting etc..
Four x Trio speld fan connectors supporting 12V ventilatoren. Fan monitoring hardware.
Fitted with Arctic F12 fan and high spectacle heatsink on each array FPGA.
Stacking Poles 75mm – order code CM1-STACK-75MM
Stacking Piles 38.4mm – order code CM1-STACK-38MM4
Power Jumper – order code CM1-POWERJUMPER
Two stacked boards(75mm stacker) powered from ATX PCIE power connector using Power Jumper
UP/DOWN 10CM Gegevens Cable – order code CM1- UPDOWN-10CM
UP/DOWN 20CM Gegevens Cable – order code CM1- UPDOWN-20CM
UP/DOWN 30CM Gegevens Cable – order code CM1- UPDOWN-30CM
UP/DOWN 40CM Gegevens Cable – order code CM1- UPDOWN-40CM
Power Distribution Houtvezelplaat – order code CM1- POWERDIST1
Wiring Looms – Made for connecting the Power Distribution Houtvezelplaat to individual boards each loom connects Three boards. Wij make thesis custom-made to your stack so voeling us with your requirement.
Power Distribution Houtvezelplaat permits the use of ATX power supplies to power large stacks of Cairnsmore1. It takes the power from the ATX PCIE cables to terminals for numerous custom-made wiring strings to on individual Cairnsmore1’s. This unit also has a switch to turn on/off the ATX supply. The number of boards supported by this product is dependent on the host power supply but can be up to about 20 Cairnsmore1 boards.